[. . . ] slightly to normally soiled textiles made of cotton and/or synthetic fibres. Hardly worn outer and sport clothing made of cotton, polyester, polyamid and mixed cotton fabrics. Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable. 0 – – – ❉ – – – – ❉ – – – ❉ Gentle spin Essorage court Intensive Spin Essorage Rinse + Spin Rinçage + Essorage 1) 2) B C D ❉ ❉ ❉ For improved garment care spin speed is restricted to 1000 rpm in this programme. [. . . ] By pressing the Start Delay button again after the “12” setting, the time delay can be deleted again or set again. € After the “Start Delay” has been started: The preset number of hours can be reduced by pressing the “Start Delay” button again; please note, however, that the washing programme starts IMMEDIATELY, as soon as you activate it again with the Start Delay switch 3 setting. To increase the number of hours preselected, first turn the programme selector switch to the “Off” position. Then set the programme and the additional options again and select the desired number of hours. PROGRAMME START After you have selected the programme and the additional option, the indicator light over the “Start” button flashes. Turn on the tap and start the programme by pressing the “Start” button. In addition, all programme phases are indicated by the associated lights. After the end of a programme phase the associated indicator light goes out. Thus the programme sequence indicator moves from left to right across the wash, rinse and spin phases. At the end of the programme only the “End” indicator is still on. DOOR LOCKED INDICATOR As long as a washing programme is running, the lamp lights up to show that the door cannot be opened. If “Start” has been pressed, but the door is not latched, the “Door locked” indicator flashes for 10 seconds. After the 10 seconds, the “Door locked” indicator goes out and the “Start” button flashes. The door must then be opened and closed again and the “Start” button must be pressed. “TROUBLE” INDICATORS “Pump” Waste water is not pumped out. Check wether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use (“Removing the Filter”). “Water Tap” The appliance has no or insufficient water supply. Open the water tap; if the indication still lights up, refer to the “Troubleshooting Guide” in the Instructions for Use. RESELECT AFTER PROGRAMME START A newly-selected programme will continue in the same programme section during which the current programme was interrupted. Select the new programme (with temperature), any additional options and - if you wish another spin speed. [. . . ] € This option is particularly suitable for areas with very soft water, washing baby linen and helps people with detergent allergies. €Rinse Hold” button • The laundry remains in the last rinse water without being spun: discoloration of the laundry and additional creasing are prevented. Note: The programme has reached the “Rinse Hold” when the corresponding light flashes. Terminate the “Rinse Hold” option: • Press the “Rinse Hold” button again; the programme will terminate automatically with the appropriate spin cycle for the current programme. [. . . ]